Dynaudio Xeo Serie Manual Del Usuario página 21

Connection
1. Position the loudspeaker in the desired location.
2. Connect the loudspeaker to the mains voltage using the power cable.
3. In stereo mode:
- Select Left operating mode for the left loudspeaker.
- Select Right operating mode for the right loudspeaker.
In mono: Select Mono operating mode.
4. Select room 1, 2, or 3. In stereo, select the same room setting for the right and left loudspeakers.
Loudspeakers with different room settings can be controlled separately via the remote control.
Operation
1. Switch the loudspeaker on using the power switch on the rear.
2. To activate the loudspeaker: Point the remote control at the loudspeaker and press
▼ If there is no input signal, the loudspeaker will go into standby mode after a certain period.
To reactivate it, press ON.
3. To deactivate the loudspeaker: Point the remote control at the loudspeaker and press
▼ The loudspeaker will go into standby mode. If you would like to completely switch off the
loudspeaker, the POWER switch on the rear must be turned to OFF. However, the loudspeaker
can then no longer be activated via the remote control.
4. To select a transmitter: Press TRANSMITTER
▼ You do not need to make a selection if you are only using one transmitter (e.g. A). If you have
accidentally selected another transmitter, select transmitter A again.
5. To select a signal source: Press INPUT
▼ The selected signal source will be played back.
A, B, or C.
1, 2, or 3.
EN
ON.
OFF.
21