Bosch Vision 300 Serie Manual Del Usuario página 10

9. Remove the four screws holding
the front ring to the door body.
10. Flip the door over so the front ring
faces up.
11. Remove the front ring from the
dryer door.
12. The cover glass has a raised glass
edge that goes about two thirds
of the way around the glass. Be
sure this raised edge faces up
towards you. Observe the position
of the leading edge of the raised
glass handle, marked in the
illustration below as (A).
Rotate the cover glass 90 degrees
clockwise.
13. Note the new position of the cover
glass. The leading edge of the
raised glass edge should have
moved 90 degrees clockwise from
its starting point as shown in the
illustration below as (A).
14. Rotate the front ring 180 degrees
so the door handle is now on the
right hand side. The door handle
is located on the inside of the front
ring. It is a hand-sized indent.
15. Flip the door over so the back
faces up.
16. Reassemble the parts, preserving
their new alignments.
17. Reinsert the single screw that goes
under the striker plate. Tighten the
screw securely.
18. Rotate the striker cover and striker
180 degrees so the assembly fits
to the install area on the opposite
side of the door (where the hinge
had been). Reinstall the striker
cover and striker to the new
location and securely tighten the
two cover screws.
19. Reinsert and tighten the four front
ring screws.
20. Remove the two screws holding
the plastic cover plate over the left
hand hinge mounting position on
the dryer housing. Remove the
plate and set it aside with the two
screws.
21. Remove the two screws holding
the metal door hinge to the dryer
housing. Remove the hinge from
the housing.
Right Hand to Left Hand
22. Reattach the door hinge to the
dryer housing at the left side of the
dryer door opening. Tighten both
screws completely, making sure
they hold the hinge securely.
23. The door is now ready to be
mounted back on the dryer.
10