Cleaning The Lint Filter - Bosch Vision 300 Serie Manual Del Usuario

10. Rotate the program selector
to "Off".
The dryer light goes out.
11. Clean the filter.
The filter should be cleaned after
each drying process. Cleaning the
filter reduces the drying time and
saves energy.
12. Close the door.
Cleaning the lint filter
A dirty filter extends the drying time and
increases energy consumption.
The filter should be cleaned before
each laundry load.
If a warning signal and a "CLn" or
"E:I 2" warning message are emitted
durinc a drying program, clean the filter
immediately and check the exhaust
duct.
D The program interrupts
automatically.
Do not rinse or wash the screen to
remove lint. Wet lint is harder to
remove. Roll the dry lint off with your
fingers. You can moisten your fingers
lightly for better results.
To clean the lint filter follow these steps:
1. Switch off the dryer by turning the
program selector to "Off".
The inside of the door heats up
during the drying process. Avoid
touching any heated surface until it
has time to cool.
2. Open the door.
3. Remove the lint filter.
4. Remove lint by stroking your hand
over the filter.
5. Insert the filter.
6. Close the door.
D Do not operate the dryer
without the lint filter in place!
Removing Residue Buildup
Laundry detergent and fabric softener
can build up on the lint filter screen.
This buildup can cause longer drying
times. Use of dryer sheets is not
recommended. If you choose to use
dryer sheets, please clean the lint filter
periodically to remove residue.
D If lint falls off the screen while it is in
the dryer, residue buildup probably
needs to be removed.
The filter should be lightly scrubbed at
least twice a year with warm soapy
water. A filter with residue buildup will
tend to hold water even though the
mesh is lint free. The filter is clean
when it no longer holds water. The
filter must be dried thoroughly before
being inserted back into the dryer.
To remove residue, follow these steps:
1. Clean all lint from the lint filter.
2. Wet both sides of the filter mesh
with hot water.
3. Wet a soft nylon brush with hot
water and liquid detergent.
4. Lightly scrub the lint screen with
the brush to remove residue
buildup. Be careful not to damage
the screen.
5. Rinse the screen with hot water.
6. Thoroughly dry the lint screen with
a clean towel.
7. Replace the lint filter back into the
dryer.
D Do not operate the dryer
without the lint filter in place!
27