Connecting The Cuff To The Monitor; Applying The Cuff; Body Posture During Measurement; Taking Your Blood Pressure Reading - Gima KD-735 Guía De Uso

27

3. Connecting the cuff to the monitor

The cuff is attached to the monitor when
it is packaged. Should the cuff become
unattached, align the two plugs and four
brackets of the cuff with the plug sockets
and bracket sockets of the monitor and press
the cuff to the monitor until the plugs
and brackets are securely attached.

4. Applying the cuff

a. Place the cuff around a bare wrist 1-2cm above the wrist
joint on the palm side of the wrist.
b. While seated, place the arm with the cuffed wrist in front
of your body on a desk or table with the palm up.
If the cuff is correctly placed, you can read the LCD display.
c. The cuff must be neither too tight nor too loose.
Note:
1. Please refer to the cuff circumference range in "SPECIFICATIONS"
to make sure that the appropriate cuff is used.
2. Measuring on same wrist each time.
3. Do not move your arm, body, or the monitor during measurement.
4. Stay quiet, calm for 5 minutes before blood pressure measurement.
5. Please keep the cuff clean. If the cuff becomes dirty, remove it from
the monitor and clear it by hand in a mild detergent, then rinse it
thoroughly in cold water. Never dry the cuff in clothes dryer or iron it.
Clean the cuff after the usage of every 200 times is recommended.

5. Body posture during measurement

Sitting Comfortably Measurement
a. Be seated with your feet flat on the floor,
and don't cross your legs.
b. Place palm upside in front of you on a flat surface
such as a desk or table.
c. The middle of the cuff should be at the level
of the right atrium of the heart.

6. Taking your blood pressure reading

a. After applying the cuff and your body
is in a comfortable position, press the "START"
ENGLISH