Operation Instructions; Safety Valve; Service - DRESTER X Serie Manual De Operación

OPERATING INSTRUCTIONS
Empty the spray-gun of any residual paint into a separate
spills-dish.
Open the main valve for compressed air (item 8 illustration 1).
Open the lid, and place the spray-gun inside (illustration 10,
11 and 12). Be sure to fi t the trigger clip (Illustration 13) and
connect the air line (item 1 illustration 10). Gravity-fed spray-
guns also require an extension pipe (item 2 illustration 10).
For the gravity-fed spray-gun, you always get the best cleaning
result if the spray-gun is dismantled and placed in the washing
compartment as seen in illustration 10.
The air line (item 1 illustration 10) prevents solvent from enter-
ing the spray-gun's air channels during washing. This air line
should be equipped with a conical plug that fi ts into the spray-
gun's air inlet (illustration 14).
Close the lid, and start the automatic pre-wash cycle by turn-
ing the Timer knob (item 9 illustration 1). The spray-gun will
now be automatically cleaned for 1 to approx. 4 minutes with
circulating solvent.
When the cleaning procedure is completed, the lid can be
opened and the spray-gun taken out. It can now be manually
rinsed with clean solvent if required. As long as the valve (item
10 illustration 1) is turned on, a jet of clean solvent will be
sprayed from the nozzle under the lid.
Finally, it is possible to blow out the spray-gun. Connect the
spray-gun to the air line on the left side of the machine (item 5
illustration 1), and blow out the spray-gun through the funnel
under the lid. By using this funnel, you prevent the fumes from
spreading within the premises.
Close the lid after cleaning.
Finally, all of the spray-gun's channels can be blown out with
the air-gun on the right side of the unit (item 6 illustration 1),
which can also be used to dry the spray-gun.
230503 rev2 2017-03-08

SAFETY VALVE

The unit is equipped with a safety valve that will interrupt the
automatic pre-wash cycle if the lid is opened before the cycle
is completed. To resume the interrupted cycle, the lid and the
unit's main valve (item 8 illustration 1) must be closed. When
you hear the safety valve 'click', the main valve can be opened
again.
To speed this process up, open the valve to activate the spray
nozzle (item 10 illustration 1) and close it when you hear the
safety valve 'click'.

SERVICE

Weekly:
– Loosen the centre bolt holding the spray-cradle and remove
it.
– Clean the washing compartment´s working platform (per-
forated pressing) and the bottom of the washing compart-
ment.
– Reassemble the parts.
Monthly:
– Remove the fi ve nozzles automatic washer and clean them
with clean solvent. (illustration 15).
When changing drums:
– Check and if necessary clean the strainer on the suction
hose for circulating solvent.
5