Set Up Network Connection; Specify The Ip Address Settings - Canon imageRunner C1028i Guía De Inicio

2 Set Up the Machine

Set Up Network Connection

To use the machine by connecting to the network, you must set up the IP address.
An IP (Internet Protocol) address is an identiication number assigned to each individual computer connected
to the Internet.
To use the following functions, you must set up the IP address in advance.
Remote UI: Access and change the machine settings from a web browser on the computer by using the remote UI software.
E-Mail: Send scanned documents attached to an e-mail message through a network.
Scan to File Server: Send a scanned document to a ile server from the computer.
I-Fax: Send a document to a machine that is compatible with I-fax.
PC Print: Print documents on a computer.
PC Fax: Fax a document on a computer.
Scan with Color Network ScanGear (application on the UFRII LT/FAX User Software CD-ROM):
Save scanned documents to a computer.
The low chart below indicates the settings needed for each function.
If the machine is connected to an IEEE802.1X network, you also need to conigure the IEEE802.1X Settings. (See "Network Settings, "
in the e-Manual.)
Specify the IP Address Settings
An IP address must be speciied in order to enable communication between the machine and computer.
–
It is recommended that the network administrator perform the following procedure.
–
Before performing the following procedure, make sure that the machine is turned on and connected to a network.
–
This machine supports automatic IP addresses using DHCP, BOOTP and RARP protocols. If you use these protocols, select <Obtain
Automatically> at step 9 of the following procedure.
–
This machine supports IPv6. (See "Network Settings, " in the e-Manual.)
The display returns to the Standby mode:
●
The machine may enter the Standby mode (Auto Clear function) while you are setting it up. Make the setting again from the main menu. The default setting is 2 minutes.
To change the settings, see "Introduction of the Machine" in the e-Manual.
The display turned OFF:
●
The machine may enter the Sleep mode while you are performing setup. Press
15 minutes. To change the settings, see "Introduction of the Machine" in the e-Manual.
18
(Power) to turn the display back ON and continue the setup. The default setting is