Set Date And Time - Canon imageRunner C1028i Guía De Inicio

2 Set Up the Machine
Make sure that the country/region is set correctly for your
country/region.
If the country/region is not set or set incorrectly, you may
have problems in sending/receiving faxes.

Set Date and Time

Before using the machine, you MUST set the current date and time. The date and time settings are used as
standard for timer settings functions.
Information About the Keys
●
Press [ ▼ ] [ ▲ ] [ ◀ ] [ ▶ ] to move the cursor position.
‒
Use (Scroll Wheel) to move the cursor position.
‒
Press the Left/Right Any key to select the alternative key at the bottom of the display.
‒
Press - (numeric keys) to enter numbers.
‒
Press [OK] to set the entry or to proceed to the next screen.
‒
Press [Back] to return to the previous screen.
‒
Press (Clear) to delete the entire entry.
‒
The display returns to the Standby mode:
●
The machine may enter the Standby mode (Auto Clear function) while you are setting it up. Make the setting again from the main menu. The default setting is 2 minutes.
To change the settings, see "Introduction of the Machine" in the e-Manual.
The display turned OFF:
●
The machine may enter the Sleep mode while you are performing setup. Press
minutes. To change the settings, see "Introduction of the Machine" in the e-Manual.
4
4
The main screen appears on the display as
shown below.
<Direct Print> is displayed only if <Direct Print> in
<Memory Media Settings> is set to <On>. (See "Security, "
in the e-Manual.)
(Power) to turn the display back ON and continue the setup. The default setting is 15