Connect Ice Maker Water Supply Line (Some Models) - Amana BR22S6E Manual De Uso

10. Rehang doors by replacing bottom, center, and top
hinges, along with freezer and refrigerator doors on
opposite side of refrigerator performing steps 2–8 in
reverse order.
• Move plastic plug from left side of bottom hinge to
right side. Pinch tabs from underside of hinge to
remove.
• Use a penny at top to space door
from cabinet.
• handle side of door should be approximately
(3 mm) higher than hinge side.
Door spacing
11. Replace freezer door handle.
• Mount handle to opposite side of door using
mounting screws removed in previous step.
• Angle front edge of handle cap downward toward
back lip of freezer handle. Verify bottom tab on
freezer cap slides under rear lip of freezer handle.
Snap rear edge of handle cap in place. Place 2
button plugs in empty mounting holes.
A. Handle cap
C. Freezer handle
Handle replacement
12. Replace refrigerator door handles.
• Pry button plugs from hinge side of door with putty
knife, blade covered with masking tape. Mount
handle on opposite side of door using mounting
screws removed previously.
• Snap end caps into place. Replace 4 button plugs
in empty mounting holes.
3
/ " (18 mm)
4
1 / "
8
3
/ "
4
A
B
C
B. Screws
Connect Ice Maker Water Supply Line
(some models)
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before connecting water supply. After
1
/ "
8
replacing doors connect power.
Observe the following to avoid property damage:
• Make sure water pressure to water valve is between
20 and 100 pounds per square inch.
• Tighten adapter fitting and nuts with pliers and
wewrenches. Do not overtighten.
• Check for water leaks and correct if necessary
before retruning refrigerator to normal location. After
24 hours check again for leaks.
Important
• Before connecting water supply, contact plumber to
connect copper tubing to household plumbing in
compliance with local codes and ordinances.
• Amana does not recommend using a self-piercing, or
3
/ " saddle valve! Both reduce water flow, become
16
clogged with time and in addition may cause leaks if
repair is attempted. The correct type of shut-off valve
1
requires a / " hole to be drilled in the water supply
4
pipe prior to valve attachement. Amana is not
responsible for property damage cuased by improper
water connection.
Materials Required
1
/ " O.D. (6 mm) flexible copper tubing is required.
4
Length of copper tubing must reach from water supply
connection to water valve inlet port on back of
refrigerator, plus an additional 8 ft. (2 m) of tubing for a
service loop. A service loop will allow refrigerator to be
pulled away from the wall without disconnecting tubing.
6
WARNING
CAUTION