Fellowes Cambio Manual Del Usuario página 5

STEP 6
Connecting cords
Turn over the desk frame with the crossbar facing up. At least two people are
required when turning over the desk frame.
WARNING If only one person turns over the desk frame, serious bodily injuries might occur.
• Connect the two motor cords to the two ports on either side of the control box marked "M1"
and "M2".
• Connect the controller cord to the port marked "HS".
• Insert the power cord in the port marked "AC".
• Align the fixing plate with the right end of the control box's slot. Slide the control box into
the fixing plate from the left until the control box can't be moved.
*Note: Please make sure the slot on the control box is facing upward. There is no corresponding relation
between the two motor ports and the two lifting columns.
**Note: The picture of the controller is for your reference only. Actual product may vary.
ACCESSORY INSTALLATION - CABLE MANAGEMENT TRAY
Cable management tray
• Align the mounting holes on the tray hangers
with the screw holes on the cable management
tray. Assemble the tray hangers with 4 Phillips
Head screws from underneath using a Phillips
screwdriver.
• Hang the cable management tray on the crossbar.
• Tighten the knobs on the tray hangers.
1
H
I
Q
J
G
C
2
5