Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Install Damper Assembly
(for roof venting only)
1. Check that damper blade moves freely, and opens fully.
2. Position the damper assembly on the top of microwave oven
so that the damper blade hinge is at the top, and the damper
blade opens away from the microwave oven.
A. Screws
B. Damper blade
C. Damper assembly
D. Top of the microwave oven
3. Secure damper assembly with two sheet metal screws
5/32" x 5/16" (4 mm x 8 mm).
NOTE: To ensure good performance of airflow, for Wall and Roof
venting, remove the charcoal filter from the bottom plate before
operating the microwave oven.
Grease Filter
Vent Cover Installation
(for both wall and upper vent installation)
1. Remove screws attaching B and C covers. Slide them out.
Keep cover C for use in Step 2.
B
C
B
A. Screw
B. Recirculation vent covers
C. Recirculation lighting cover
NOTE: Keep B for future recirculation vent installation.
6
A
B
C
D
Charcoal Filter
A
2. Rotate C 180 degrees, place it as shown below.
C
C. Recirculation lighting cover
3. Take J from packaging upper foam (see item J in "Parts
Supplied" section), attach both of them as shown below with
screw removed from step 1.
J
A. Screws
J. Exhaust vent covers
Locate Wall Stud(s)
NOTE: If no wall studs exist within the cabinet opening, do not
install the microwave oven.
See illustrations in "Possible Wall Stud Configurations."
1. Using a stud finder, locate the edges of the wall stud(s)
within the opening.
2. Mark the center of each stud and draw a plumb line down
each stud center. See illustrations in "Possible Wall Stud
Configurations."
A
Publicidad
Tabla de contenido
