Charging The Rechargeable Battery; Maintenance And Care; Troubleshooting - OWIM Melinera HG03854A Instrucciones De Utilización Y De Seguridad

1. Separate the solar cell housing
by moving it anti-clockwise (see Fig. A). Switch off the
2
light with the ON- / OFF-switch
2. Loosen the fastening screws
head screwdriver and then lever out the battery compart-
ment lid
slot screwdriver (see Fig. B).
3. Take care not to damage the cables and cable connections
(see Fig. B).
4. Exchange the old rechargeable battery
Take care about the correct polarity, when inserting the
new rechargeable battery. The polarity is indicated in the
battery compartment. The new rechargeable battery has
to have the same technical data like the old one.
5. Now again fasten the battery compartment lid
the fastening screws
driver. Slide the ON / OFF switch
6. Connect the solar cell housing
shade
each other (see Fig. C).

Charging the rechargeable battery

Note that the product must be switched on when the recharge-
able battery is charging.
The charging time of the rechargeable battery when the solar
cell is used depends on the intensity of the sunlight and the
angle of incidence of the light on the solar cell. Place the solar
cell as perpendicular as possible to the angle of incidence of
the light. In this way you will receive the highest light levels.

Maintenance and care

The LED cannot be replaced. The product is maintenance-free,
except for any necessary change of rechargeable battery.
Clean the product regularly with a dry, lint-free cloth. Use a
slightly dampened cloth to remove more stubborn dirt.

Troubleshooting

Note: This product has delicate electronic components. This
means that if it is placed near an object that transmits radio
signals, it could cause interference. If you notice that the
product is malfunctioning, remove any sources of interference
from the area of the product.
18 GB/IE
of the solar cell housing
7
6
and then connect every part of the product to
2
from the lamp shade
1
.
5
by using a small cross
6
1
by using a small cross head screw-
to the position ON.
5
again to the lamp
1
with the help of a
to a new one.
8
, fasten
7