gala gar SMART 200 TIG PULSE Manual Técnico De Instrucciones página 25

Press the 'selection
knob'
Step two: Adjust the'selection knob'and select the pre flow time LED (L1 is on); Press the 'selection knob' again, the
pre flow time LED (L1) is twinkling; It means the pre flow time can be adjusted.
Adjust the 'selection knob' and
select the pre flow time LED (L1 is
on); Press the 'selection knob'
again, the pre flow time LED (L1)
is twinkling; It means the pre flow
time can be adjusted
Step three: If the adjustment is completed, confirm the parameter by pressing the 'selection knob'; or the system will
confirm the parameter automatically after 3 seconds
If the adjustment is
complete, confirm the
parameter by pressing the
'selection knob'; or the
system will confirm the
parameter automatically
after 3 seconds
.
Output pulse selection: Press the 'selection knob'. Adjust the'selection knob'and select the pulse LED (L11 is on); press
the 'selection knob' again, the pulse LED (L11) is twinkling; It means the output pulse function can be turned on or
turned off. If the display is "ON", the output pulse function is turned on; if the display is "OFF", the output pulse
function is turned off. When the pulse LED (L11) is twinkling, press the 'selection knob' again, the output pulsed
conditions transform by "ON" into "OFF" or transform by "OFF" into "ON". Operation flow as follows:
Step one: 'Welding mode selection switch' select TIG 4T or 2T. Press the 'selection knob':
Press the 'selection
knob'
SMART 200 TIG PULSE
Select TIG 4T or
2T
Select TIG 4T or
2T
25