Description Of Controls - Saeco DEU 001 Manual De Instalación Y De Uso

18
LIST OF THE CONTROLS AND INDICATORS (MIRAGE/MIRAGE COMBI) (FIG. E - F)
CONTROL NAME
Dehumidification adjustment
knob
ON/OFF push button / LED
Air speed selection push
button /LED
Condensation collection
tank full LED
Running mode
Push button/LEDs
Electronic thermostat push
button /LEDs

DESCRIPTION OF CONTROLS

Dehumidification
Combi
Heating
Minimum
Medium
Maximum
DESCRIPTION
Adjusts the humidity level of the room
= minimum dehumidification
= Max. dehumidification
This push button is used to turn the dehumidifier on and off. The
dehumidifier starts in the running mode in which it was set when
turned off.
This push button is used to select the air flow speed through the
dehumidifier. The two fan speeds are alternately elected by
pressing this push button. The LED lights up when the maximum
speed is selected.
This LED points out that the maximum level in the condensation
collection tank has been reached. The dehumidifier will stop
automatically when this occurs.
The running mode of the dehumidifier may be selected using this
push button.
Upon starting, the dehumidifier enters the Dehumidification
mode; the corresponding LED lights up.
Press the push button once to select the Combi running mode;
both LEDs will light up. The unit dehumidifies and heats the air
in this running mode.
Press the push button twice to set the dehumidifier in the Heating
mode. The corresponding LED remains lit. If pressed again, the
dehumidifier returns to the starting status.
The fan always runs at full speed in the Heating and Combi mode.
This push button is used to select between three different pre-set
room temperatures that are controlled by the electronic thermostat.
This function is enabled only when the Combi and Heating modes
are selected.
The first time that the Combi and Heating modes are selected
the electronic thermostat is set at the Minimum temperature.
Press the push button to select the Medium and Maximum tem-
perature; the machine will heat the room until the desired tempe-
rature is reached.
DESCRIPTION OF CONTROLS