quiko ERCOLE QK-E2500 Manual De Instrucciones página 2

1) ATTENTION! To ensure the safety of people, it is
important that you read all the following
instructions. Incorrect installation or incorrect use
of the product could cause serious harm to people.
2) Carefully read the instructions before beginning to
install the product.
3) Do not leave packing materials (plastic, polystyrene,
etc.) within reach of children as such materials are
potential sources of danger.
4) Store these instructions for future reference.
5) This product was designed and built strictly for the
use indicated in this documentation. Any other use, not
expressly indicated here, could compromise the good
condition/operation of the product and/or be a source of
danger.
6) QUIKO declines all liability caused by
improper use or use other than that for which the
automated system was intended.
7) Do not install the equipment in an explosive
atmosphere: the presence of inflammable gas or fumes
is a serious danger to safety.
8) The mechanical parts must conform to the
provisions of Standards EN 12604 and EN 12605.
For non-EU countries, to obtain an adequate level of
safety, the Standards mentioned above must be
observed, in addition to national legal regulations.
9) QUIKO is not responsible for failure to
observe Good Technique in the construction of the
closing elements to be motorised, or for any
deformation that may occur during use.
10) The installation must conform to Standards EN
12453 and EN 12445. For non-EU countries, to obtain
an adequate level of safety, the Standards mentioned
above must be observed, in addition to national legal
regulations.
11) Before attempting any job on the system, cut out
electrical power.
12) The mains power supply of the automated system
must be fitted with an all-pole switch with contact
opening distance of 3mm or greater. Use of a 6A
thermal breaker with all-pole circuit break is
recommended.
WARNINGS FOR THE INSTALLER
GENERAL SAFETY OBLIGATIONS
13) Make sure that a differential switch with threshold of
0.03 A is fitted upstream of the system.
14) Make sure that the earthing system is perfectly
constructed, and connect metal parts of the means of
the closure to it.
15) The safety devices (EN 12978 standard) protect
any danger areas against mechanical movement
Risks, such as crushing, dragging, and shearing.
16) Use of at least one indicator-light is recommended
for every system, as well as a warning sign adequately
secured to the frame structure, in addition to the safety
devices.
17) QUIKO declines all liability as concerns
safety and efficient operation of the automated system,
if system components not produced by
are used.
18) For maintenance, strictly use original parts by
QUIKO
19) Do not in any way modify the components of the
automated system.
20) The installer shall supply all information concerning
manual operation of the system in case of an
emergency, and shall hand over to the user the
warnings handbook supplied with the product.
21) Do not allow children or adults to stay near the
product while it is operating.
22) Keep radiocontrols or other pulse generators away
from children, to prevent the automated system from
being activated involuntarily.
23) The user must not attempt any kind of repair or
direct action whatever and contact qualified personnel
only.
24) Transit is permitted only when the automated
system is idle.
25) Maintenance: check at least every 6 months the
efficiency of the system, particularly the efficiency of
the safety devices (including, where foreseen, the
operator thrust force) and of the release devices.
26) Anything not expressly specified in these
instructions is not permitted.