Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Close door and lock the Latch by pressing firmly.
8.
Check that Switch is in OFF position and hands are dried. Plug cord
into standard grounded 120 V.a.c. outlet. If grounded outlet is not
available use adapter as shown on page 2.
9.
Flip Switch to ON position and allow "Tumble Drumm™" to operate
about 10 to 25 minutes. Times will vary due to size / type / number of
fish per load.
10. Turn switch to OFF position and allow Drum to stop rotating. Release
latch, open door and inspect fish. Drum has sharp edges that can
cause cuts and abrasions. CAUTION: ALWAYS WEAR SAFETY
GLOVES WHEN REACHING INSIDE OF DRUM!
11. If more time is needed to remove scales, close door and lock latch.
Operate a few minutes longer, check frequently to avoid damaged
fish.
12. When fish are completely scaled, turn Switch to OFF position and
unplug cord from outlet.
13. Remove Drum from Tub by lifting opposite end of Motor Drive, then
slide Drum away from Motor Drive while lifting to remove.
14. Release Latch and open door. Dump fish into suitable container.
15. Rinse Drum with hose. Repeat steps as needed.
Care and Cleaning
1.
Be sure cord is disconnected from outlet and switch in OFF position.
2.
Remove Drum from Tub and rinse with clean water. Drum has sharp
edges that can cause cuts and abrasions. CAUTION: ALWAYS
WEAR SAFETY GLOVES WHEN REACHING INSIDE OF DRUM!
3.
Dump the dirty water by tilting Tub with Motor Drive upwards. Rinse
with clean water. NOTE: If scales are dried, try soaking parts by filling
Tub with warm soapy water to the Maximum Fill Line, add Drum and
cycle without fish for several minutes.
4.
Rinse all parts separately and allow to dry thoroughly. The Tub and
Motor Drive can be wiped with dry cloth.
5.
When all parts have dried, assemble Drum or store Drum in bottom of
Tub.
6.
Store indoors in a dry place. Do not expose to rain.
4
Publicidad
Tabla de contenido
