Product Disposal - BATSI MIE210RPM Manual De Uso

INTRODUCTION
This instruction manual has been written by the controller manufacturer and is an ex-
clusive part of the product. The operations contained are addressed to properly trained
and qualifi ed personnel. It is recommended to be read and stored for future reference.
TERMS OF USE
BATSI® recommends the installation of all devices, equipment and materials, com-
plying with European Directives 2006/42 / EC (Machinery Directive), 2014/30 / EU
and subsequent modifi cations (low voltage electrical equipment). Non-EU coun-
tries, in addition to existing national standards and for a suffi cient level of safety, it is
also recommended to comply with the indications contained in the above Directives.

PRODUCT DISPOSAL

In accordance with the EU Directive 2012/19 / EU on Waste Electrical and Electronic Equi-
pment (WEEE), this electronic product can not be disposed of with other unclassifi ed was-
te. Dispose of this equipment by returning it to a local collection point for recycling.
MIE210RPM MODULE OPERATION
The MIE 210RPM module is capable of counting revolution per minute of any element that we
want to be monitored.
The equipment includes the possibility of setting a minimum level of RPM. If a minimum speed is
set, an acoustic alarm be given while the RPM level will be below to the minimum level confi gured.
Following this manual it will be explained in more detail.
RPM MINIMUM CONFIGURATION
This product allows you to know when the desired RPM has been reached. When a mini-
mum RPM level have been confi gured, MIE210RPM will emit an acoustic signal until the-
se RPMs are reached (to emit an acoustic signal the sensor must read more than 0 RPM).
To set the minimum RPM press the button for 4 seconds until the "<-" button appears
on the lower right side of the screen. Once it appears press the same button to increase the
minimum RPM. The value increases every 10 while the value is below 1000 and every 100 af-
ter this point, and 6000 is the maximum value. To validate, you have to press the same bu-
tton for 4 seconds or wait 5 seconds if you want to cancel the RPM min confi guration.
Press until the desired value appears
4s pressing
4