Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
NOTE:
If installing the SL151i in a drywall ceiling, remove the
outside terminal block and cover with plate (C), using
four 6-32 x 3/16" Phillips pan head screws (F).
Wiring Options
NOTE:
Refer to Table 1: Wiring Table and (See Figure 16) for
information on all wiring options.
NOTE:
Refer to Table 2: Terminal Descriptions and (See
Figure 16) for terminal descriptions, functions and
wiring options.
Re-Attaching Ceiling Panel
1.
Line up rectangular holes in ceiling panel with clips on ends
of rods, and re-attach the ceiling panel. (See Figure 14)
CAUTION:
Damage to equipment could result if clips are
not lined up properly with rectangular holes.
Clips
Figure 14
2.
Carefully insert clips into rectangular holes in ceiling panel.
3.
Reattach guide wires (two places) to ceiling panel, using
screws removed earlier. (See Figure 15)
Rectangular
Holes
Ceiling
Panel
Guide
Wire
x 2
Figure 15
SL151i
9
Publicidad
Capítulos
Tabla de contenido
