Electrical Installation - Stuart SM4 Instrucciones De Utilizacion

English
Speed controller
Figure 1: SM4 magnetic stirrer
SM4 MAGNETIC STIRRER
Thank you for purchasing this Stuart product. To
get the best performance from the equipment,
and for your own safety, please read these
instructions carefully before use.
This equipment is designed to operate under the
following conditions: -
❖ For indoor use only
❖ Use in a well ventilated area
❖ Ambient temperature +5°C to +40°C
❖ Altitude to 2000m
❖ Relative humidity not exceeding 80%
❖ Mains supply fluctuation not >10%
❖ Overvoltage category II IEC60364-4-443
❖ Pollution degree 2 IEC664
❖ Use with a minimum distance all around of
200mm from walls or other items

Electrical Installation

THIS EQUIPMENT MUST BE EARTHED
Before connection please ensure that the line
supply corresponds to that stated on the rating
label. The SM4 model requires a supply rated at
220-240Vac, 50Hz single phase.
6
4
7
8
1
9
0
10
+
z
'Z' control
There is an IEC socket at the rear on the left
hand side of the instrument for connection to
the mains supply, (see figure 1). The unit is
supplied with two mains leads fitted with IEC
plugs for connection to the instrument. One has
a U.K. 3 pin plug and the other has a 2 pin
"Shuko" plug for connection to the mains
supply. Choose the lead appropriate for your
electrical installation and discard the other.
Should neither lead be suitable you should
obtain a moulded lead locally. If this is not
possible, take the lead with the U.K. plug and
replace the plug with a suitable alternative.
Should the mains lead require replacement a
cable of 1mm 2 of harmonised code H05V V-F
connected to an IEC 320 plug should be used.
N.B. The UK mains lead is protected by a 10A
fuse mounted in the plug top.
The mains lead should be connected to the
instrument BEFORE connection to the mains
supply.
IF IN DOUBT CONSULT A QUALIFIED
ELECTRICIAN
Mains on/off