Step Installation Guide - Gallagher MR5000 Manual Del Usuario

4 step installation guide

Step 1
Mount the Energizer
a) For inside use only. Mount the Energizer on a wall, out of reach of children, adjacent to
a power outlet. Install where there is no risk of the Energizer incurring fi re or mechanical
damage (illustration a).
b) Using the template on centre pages, drill 3 holes (A,B & C).
Use a 4mm (5/32") diameter drill for timber walls or a suitable wall plug for brick and
concrete walls (illustration b).
c) Fix the screws provided into the wall, leaving the head of the screw about 3mm (1/8") out
from the wall (illustration c).
d) Position the Energizer over the mounting screws and slide down until it is fi rmly in place.
Step 2
Connect to Earth (Ground) System
Using Lead-out Cable G6270 remove 5cm (2") of plastic coating from one end of the cable
and attach to the green terminal on the Energizer. Attach the cable to the earth system by
removing 10cm (4") of insulation from the cable at each Earth Stake, then clamp the exposed
wire to each stake using an Earth Clamp G8760. Tighten the clamp.
For further instructions on the earth (ground) system see "How to install earth (ground)
system" section.
Step 3
Connect the Fence
Connect Energizer's red terminal to the fence using Lead-out Cable G6270: remove 5cm (2")
of plastic coating from one end of the cable and attach to the red terminal on the Energizer.
Attach the other end of the cable to the fence using a Joint Clamp G6030. For instructions on
fence installation see "How to install the fence" section.
Step 4
Plug the Energizer into a power outlet
Indicator lights give you information about the Energizer and fence.
Power/Standby Light: MR2500
Constant Green - Energizer OK, Full Power
Constant Yellow - Energizer OK, Low Power
Flashing Red - Remote Control Interference
Constant Red - Standby
Fence Light:
Flashes Green with each fence pulse over approx. 3.4kV
Flashes Red with each fence pulse below approx. 3.4kV
Handyhint
Earthing (Grounding)
Earthing the Energizer is the
key for a successful Power
Fence. Poor earthing
is the most common
reason for poor electric
fence performance. Check
the voltage on your earth system
using a Digital Volt Meter G5030.
Keep adding Earth Stakes G8790
Flashing Green
Constant Green
Constant Yellow
Flashing Red
Constant Red
Flashes Green with each fence pulse over approx. 1.0kV
Flashes Red with each fence pulse below approx. 1.0kV
until earth voltage is 200 volts
or below.
Find a location for your earth
system that is permanently damp,
has high fertility or salinity and
is away from dairy sheds. Install
the earth system at least 10m (33ft)
from any power supply earth peg,
underground telephone or power cable.
The best construction is 2m (6
Power/Standby Light: MR5000
- Energizer OK, Turbo Power
- Energizer OK, Full Power
- Energizer OK, Low Power
- Remote Control Interference
- Standby
Fence Light:
galvanised stakes G8790 or Super Earth
Kits G8800, 3m (10ft)
apart, connected to
the Energizer by high
quality Lead-out cable
G6270. Do not use
materials that rust.
(Use G6272 if the
earth system is over
100m (300ft) from the
1 /
ft) long
2
Energizer).
a
b
c
GREEN
To Earth System
RED
To Fence
G8760
G8790
5