Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NEW WARRANTY
8/29/03
6:16 PM
Figure 8
Timing
Marks
REEVING LOAD CHAIN
Installing a new length of load chain
To replace the load chain, remove the lower hook block and
chain stop from the chain. Move the directional lever to the
neutral "N" and pull the old chain out of the hoist. Feed a length
of soft wire through one side of the chain guide roller and over
the liftwheel until it comes out on the other side of the chain
guide roller.
Figure 9
Chain guide
roller-Lower
Hook Side
Stripper
Lower
Hook
Block
Attach the wire to the end of the new chain. Position the chain
so that the first link to enter the chain guide roller will be an
upstanding link and the welds on all upstanding links will be
away from the liftwheel. Pull on the wire until the chain
engages the liftwheel. Turn the free chaining knob, while pulling
on the wire, until the chain comes out of the chain guide roller.
Pull the chain through and remove the wire. Attach the lower
hook block to the chain that is directly below the upper hook.
Attach the chain stop to the other end of the chain.
To reduce the risk of injury, feed load chain between
liftwheel and chain guide before attaching the
warning tubes and end ring. Failure to properly install
the load chain may cause the chain to lift out of the
liftwheel pockets and allow the load to drop.
Page EN1
Chain Welds
Away From
Liftwheel
Liftwheel
Chain Guide
Roller-Chain
Stop Side
Chain Stop-
Position as
Shown
TESTING
Prior to initial use, all altered, repaired or used hoists that have
not been operated for the previous 12 months should be tested
by the user for proper operation. Test the unit without a load
and then with a load of 100 pounds (46 Kg) to be sure that the
hoist operates properly and that the brake holds the load when
the lever is released. Then test with a load of 125% of rated
capacity. Hoists in which load sustaining parts have been
replaced should be tested with a load of 125% of rated
capacity by, or under the direction of, an appointed person and
a written report prepared for record purposes.
ACCESSORIES
WARRANTY
For a complete listing of accessories, refer to your MILWAUKEE
Every MILWAUKEE product is warranted to be free from
Electric Tool catalog or go on-line to www.mil-electric-tool.com.
defects in material and workmanship. MILWAUKEE will repair
To obtain a catalog, contact your local distributor or a service
or replace any product which examination proves to be
center listed on the back cover of this operator's manual.
defective in material or workmanship.
Limitations: This warranty does not cover: 1) repairs made or
attempted by other than MILWAUKEE or MILWAUKEE
FIVE YEAR TOOL LIMITED WARRANTY
Authorized Service Station personnel; 2) normal wear and tear;
3) abuse; 4) misuse; 5) improper maintenance; 6) continued
Every MILWAUKEE tool is tested before leaving the factory and is
use after partial failure; 7) tools that have been modified; or
product used with an improper accessory.
warranted to be free from defects in material and workmanship.
Battery Packs are warranted for one (1) year from the date of
MILWAUKEE will repair or replace (at MILWAUKEE's discretion),
purchase.
without charge, any tool (including battery chargers) which exami-
Should a problem develop, return the complete product to any
nation proves to be defective in material or workmanship from
MILWAUKEE Factory Service Center or MILWAUKEE
five (5) years after the date of purchase. Return the tool and a
Authorized Service Station, freight prepaid and insured. If
copy of the purchase receipt or other proof of purchase to a
inspection shows the problem is caused by a defect in material
MILWAUKEE Factory Service/Sales Support Branch location or
or workmanship, all repairs or a replacement will be made at
MILWAUKEE Authorized Service Station, freight prepaid and
no charge and the product will be returned, transportation
insured. This warranty does not cover damage from repairs made
prepaid. No other warranty, written or verbal, is authorized.
or attempted by other than MILWAUKEE authorized personnel,
THE REPAIR AND REPLACEMENT REMEDIES DESCRIBED
HEREIN ARE EXCLUSIVE. IN NO EVENT SHALL
abuse, normal wear and tear, lack of maintenance, or accidents.
MILWAUKEE BE LIABLE FOR ANY INCIDENTAL, SPECIAL,
Battery Packs, Flashlights, and Radios are warranted for one (1)
OR CONSEQUENTIAL DAMAGES, INCLUDING LOSS OF
year from the date of purchase.
PROFITS.
THE REPAIR AND REPLACEMENT REMEDIES DESCRIBED
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
HEREIN ARE EXCLUSIVE. IN NO EVENT SHALL MILWAUKEE
EXPRESSED OR IMPLIED WHETHER FOR
BE LIABLE FOR ANY INCIDENTAL, SPECIAL, OR CONSE-
MERCHANTABILITY OR FITNESS FOR PARTICULAR USE
OR PURPOSE.
QUENTIAL DAMAGES, INCLUDING LOSS OF PROFITS.
This warranty gives you specific legal rights.You may also
THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL
have other rights that vary from state to state. In those
OTHER WARRANTIES, OR CONDITIONS, WRITTEN OR
states that do not allow the exclusion of implied
ORAL, EXPRESSED OR IMPLIED FOR MERCHANTABLILITY
warranties or limitations of incidental or consequential
OR FITNESS FOR PARTICULAR USE OR PURPOSE.
damages, the above limitations or exclusions may not
This warranty gives you specific legal rights.You may also
apply to you.
have other rights that vary from state to state and province
ACCESSORIES
to province. In those states that do not allow the exclusion
of implied warranties or limitation of incidental or conse-
quential damages, the above limitations or exclusions may
For a complete listing of accessories refer to your MILWAUKEE
not apply to you. This warranty applies to the United States,
Electric Tool catalog. To obtain a catalog, contact your local
Canada, and Mexico only.
distributor.
To reduce the risk of injury, use only specifically
recommended accessories. Others may be
hazardous.
9
Publicidad
Tabla de contenido
