Denon DVD-9000 Instrucciones De Operación página 15

(5) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)
Set the "AUDIO SETUP" default setting as shown below. (See page 32.)
• "DIGITAL OUT" → "PCM"
"LPCM SELECT" → "ON"
Playing DVDs with incorrect settings may result noise that could damage your ears or the speakers.
B
(6) Connecting to a Stereo Component
DVD-9000
NOTES:
• When connecting to a 2-channel audio stereo device, set "AUDIO CHANNEL" under "AUDIO SETUP" at "SETUP" to "2 CHANNEL"
(see page 29). For multi-channel sources, the signals are down-mixed into two channels (analog).
(Only the front left and right channels are output for sources for which down-mixing is prohibited.)
• Set "LPCM (44.1 kHz/48 kHz)" under "AUDIO SETUP" at "SETUP" to "OFF". (See page 32.)
(If set to "ON", analog audio signals converted to 48 kHz will be output for linear PCM or packed PCM sources.)
• Set "DIGITAL OUTPUT" at "PURE DIRECT MODE" to "OFF". (See page 54.)
(If set to "ON", analog audio signals converted to 96 kHz/88.2 kHz will be output when playing sources recorded at 196 kHz/176.4 kHz.)
8 9
Digital audio input connector (OPTICAL)
Digital audio input connector (COAXIAL)
DVD-9000
Stereo component
ENGLISH
15