Sime SOLIDA 8 PL Manual De Instrucciones página 80

H) Assemble the control panel after inserting the probes and the microswitch cable into the hole on the mantle cover. Remove the control panel
IT
cover and reassemble the cover after fixing the panel to the cover.
ES
PT
GB
Fig. 13. 1 3: Hole on cover
I) Apply the fiber glass insulation, supplied to protect the cables, on the boiler body. Then, insert the probes into the sleeve on the rear head and
connect the micro-switch cable. To protect the micro-switch cable, always verify that is it positioned inside the bend on the side of the mantle.
Close the mantle cover.
Fig. 13. 1 6: Insertion of the probes into the sheath
L) Connect the power supply line and plant pump before assembling the cable straps.
Fig. 13. 1 8: Power supply
80
Fig. 13. 1 4: Fixing of control panel
Fig. 13. 1 7: Microswitch wiring
Fig. 13. 1 9: Cable straps
Fig. 13. 1 5: Control panel cover