Care And Maintenance; Troubleshooting Guide - Aiwa MSBTU-300 Manual De Usuario

Ocultar thumbs Ver también para MSBTU-300:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 11
16
en

CARE AND MAINTENANCE

CARRYING FOR COMPACT DISCS
Treat the disc carefully. Handle the disc
1.
only by its edges.
Never allow your fingers to come in
contact with the shiny, unpainted side of
the disc.
2.
Do not attach adhesive tape, stickers, etc.
to the disc label.
3.
Clean the discs periodically with a soft,
lint-free, dry cloth.
Never use detergents or abrasive cleaners
to clean the disc.
If necessary, use a CD cleaning kit.
If a disc skips or gets stuck on a section of
the disc, it is probably dirty or damaged
(scratched).
When cleaning the disc, wipe in straight
lines from the center of the disc to the outer
edge of the disc. Never wipe in circular
motions.
4.
This unit is designed
to play discs bearing
the identification logo
as shown here or
MP3 format Disc.
Other discs may not conform to the CD
standard and may not play properly.
Discs should be stored in their cases after
5.
each use to avoid damage.
6.
Do not expose discs to direct sunlight, high
humidity, high temperatures, or dust, etc.
Prolonged exposure or extreme temperatures
can warp the disc.
Do not stick or write anything on either
7.
side of the disc.
Sharp writing instruments or the ink may
damage the surface.
CARE OF THE CABINET
1.
To prevent fire or shock hazard, disconnect
your unit from the AC power source when
cleaning.
The finish on your unit may be cleaned
2.
with a dust cloth and cared for as other
furniture. Use caution when cleaning and
wiping the plastic parts.
3.
Mild soap and a damp cloth may be used
on the front panel.
TO CLEAN THE LENS
If the lens gets dirty, your player may skip or may
not play a CD:
1.
Open the CD door.
2.
Use a camera lens blower/brush to blow
on the lens once or twice, brush the dust
or particles off the lens then blow again.
3.
To remove fingerprints, use a dry cotton
swab to wipe from the middle to outer
edge of the lens.
TROUBLE SHOOTING GUIDE
If a fault occurs, first check the points listed below before taking the set to repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
SYMPTOM
CAUSE
General
No power
The power cord is not plugged
Check whether electricity failed
No sound
Check whether you select
right function
CD
The unit does not start
An unplayable disc inserted
playback
The disc is dirty
Radio
Radio stations cannot be
The antenna is positioned or
tuned in
connected poorly
Remote control
The remote control does not
The remote control is too far
work properly
from the unit
There is an obstacle in the
path of the remote control
and the unit
The battery in the remote
control is exhausted
WARNING!
Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.
CORRECTION
Plug in the power cord
Check the condition by operation
of other electronic devices.
Press SOURCE and check the
selected function
17
Insert a playable disc
Clean the disc
Connect the antenna securely
Operate the remote control within
about 23ft (7m)
Remove the obstacle
Replace the battery with new one

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido