Using The Grip Ring With Led Light; Notes On Working With Materials/Tools/Speed Range - Parkside PFBS 160 B2 Manual De Instrucciones

Taladradora-lijadora de precisión
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 94

Using the grip ring with LED light

Hold down the spindle lock
tensioning nut
anticlockwise off the thread.
Release the spindle lock
Then screw the union nut
the thread.
Screw the grip ring with LED
the screw thread.
Hold down the spindle lock
tensioning nut
clockwise onto the thread.
Release the spindle lock
Move the ON/OFF switch of the LED light
to the position "I" to switch it on (see fig. C).
Move the ON/OFF switch of the LED light
to the position "O" to switch it off again.
Proceed in reverse order to replace the union
nut
.
Notes on working with materials/
tools/speed range
Use the milling bits for working on wood, plas-
tics and plasterboard at maximum speed.
Determine the rotational speed range for work-
ing on zinc, zinc alloys, aluminium, copper and
lead by trying it out on test pieces.
Use a low rotational speed for work on plastics
and materials with a low melting point.
Use a high rotational speed for working on
wood.
Carry out cleaning, polishing and buffing work
in the medium speed range.
NOTE
The milling bit
is not suitable for steel or
iron. Suitable products are available in stores.
PFBS 160 B2
and screw the
.
anticlockwise off
clockwise onto
and screw the
.
The following are recommendations only and not
binding. When carrying out practical work, carry
out your own tests to see which tool and which set-
tings are ideal for the material you are working on.
Set a suitable rotational speed:
Number on the speed
control
1
2–3
4
5
Max.
Material being
worked
Plastics and materials
with a low melting
point
Stone, ceramics
Soft wood, metal
Hardwood
Steel
GB │ IE
 29

Publicidad

Tabla de contenido
loading

Tabla de contenido