AGP DM6P Manual De Instrucciones Original página 9

DMC6P DRY DRILLING RECOMMENDED GEARS (soft materials)
BitØ
20mm
Gear
Gear 3
Gear 2
Gear 1
Impossible /
Not recommended
4) THE SWITCH
The machine has a lockable trigger switch. Squeeze the trigger to start the
machine. To lock the switch on, press the lock button while holding the
trigger switch on. To release, squeeze the trigger and release.
WARNING: Never lock the switch on when drilling hand-held. Only lock
the switch on when mounted to a rig.
5) OVERLOAD PROTECTION, OVERHEAT PROTECTION
Overload Warning System:
When the load reaches overload conditions, the indicator light will flash on
and off.
Overload:
If the excessive load is sustained too long, the motor will shut down
completely and the LED indicator light will glow solid red. In this case, the
motor must be first shut off and then restarted.
Overheat Thermal Protection:
If the temperature of the motor gets too high, the thermal protection will shut the motor down and the LED
indicator light will glow solid red. The switch must be first shut off and then restarted.
CAUTION: The motor will be damaged if it is repeatedly overloaded or overheated. Always cool the
motor by running at no load for a few minutes whenever it stops from either overheat or overload.
32mm 56mm
Possible
GB
132mm
Ideal
9
162mm 182mm
Lock Button
Trigger Switch
Indicator Light
DM8P
Indicator Light
DMC6P,DM6P