Maintenance - ELICA ELG630S2 Guía De Instalación, Uso Y Mantenimiento

Mainteinance
I ATTENTION!
Before performing any maintenance operation, isolate the
hood from the electrical supply by switching off at the con-
nector and removing the connector fuse.
Or if the appliance has been connected through a plug and
socket, then the plug must be removed from the socket.
Cleaning
Do not spray cleaners directly to the control while cleaning
the Hood.The cooker hood should be cleaned regularly (at
least with the same frequency with which you carry out main-
tenance of the fat filters) internally and externally. Clean using
the cloth dampened with neutral liquid detergent. Do not use
abrasive products. DO NOT USE ALCOHOL!
I WARNING
Failure to carry out the basic cleaning recommendations of
the cooker hood and replacement of the filters may cause fire
risks. Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate maintenan-
ce or failure to observe the above safety recommendations.
Grease Filter
Traps cooking grease particles. This must be cleaned once a
month using non aggressive detergents, either by hand or in
the dishwasher, which must be set to a low temperature and
a short cycle. When washed in a dishwasher, the grease filter
may discolour slightly, but this does not affect its filtering
capacity. To remove the grease filter, pull the spring release
handle.
Replacing lamps
CAUTION
Before replacing the lamps, switch power off at service panel
and lock service panel disconnecting means to prevent power
from being switched on accidentally.
NOTE: Turn off the lights and fan. Allow the lights to cool
before handling. If new lights do not operate be sure lights are
inserted correctly before calling service.
Replace Lights
Remove the inner lamp lens cover by inserting a small
flat blade screwdriver into each of the three slots and
gently prying it free.
NOTE: Do not remove the outer trim ring (lamp assembly).
Grasp the bulb and pull it straight out.
Replace with 120 volt, 40 watt halogen bulbs with a G9
base SUITABLE FOR USE IN OPEN LUMINAIRES.
Follow package directions, wear gloves, do not touch bulb
with your bare fingers.
14
A
A. Spring release handle
Replace inner cover by inserting the three retaining tabs
into the three slots and pressing them firmly in place.
Charcoal Filter
If the model is not vented to the outside, the air will be recir-
culated through disposable charcoal filters that help remove
smoke and odors.
The charcoal filters are clipped on the motor housing frame.
NOTE: Charcoal filters are not included with the hood. They
must be ordered from your supplier.
Order the needed kit specifying your hood model and width size.
Cleaning/replacing the charcoal filter
Unlike other charcoal filters, the LONGLIFE charcoal filter can
be cleaned and reactivated.
With normal use the filter should be cleaned every second
month (when using the hood 2.5 hours per day,on average).
The best way to clean the filter is in the dishwasher.
Use normal detergent and choose the highest temperature
(65º C or 149° F).
Wash the filter separately so that no food parts gets stuck on
the filter and later causes bad odours.
To reactivate the charcoal, the filter should be dried in an oven
for 10 minutes with a maximum temperature of
212° F.
After approximately one year of use, the charcoal filter should
be replaced with a new one, as the odour reduction capacity
will be reduced.
Light
bulb
Charcoal
filter
Motor
housing
frame
Charcoal
filter handle
100º C or