Adjusting The Harness - CASUALPLAY FIX QR Instrucciones De Uso

POSITIONING THE CHILD IN THE QR (illustrations 20-23)
• Press the lever down on the upper right front adjuster (fig.20) and at the same time, pull
the harness chest straps (fig.21).
• Open the harness clasp by pressing the red button (fig.22).
• The child can now be seated.
• Fasten the harness buckle (fig.23).
NOTE: If the buckle is not fastened or the child accidentally unfastens it, an alarm will
beep five times.

ADJUSTINg THE HARNESS

Adjusting the crotch strap (illustration 24)
• Press the adjuster and at the same time set it to the required position making sure that
the abdominal belt is positioned as low as possible to protect the child's pelvis (fig.24).
Adjusting the chest straps (illustrations 25-26)
• Turn one of the two rear side handles (fig.25) until the chest straps are at the height of
the child's shoulders and both at the same level (fig.26).
• The headrest moves up or down with the harness.
Tightening the harness (illustration 27)
• Turn the handle on the upper right front part to the right until the harness is fitted correctly,
taking care to always leave a small gap (fig.27).
NOTE: Do not turn the handle to the left for any adjustments
Loosening the harness (illustrations 28-29)
• Press the lever on the upper right side adjuster (fig.28) and at the same time, pull the
harness chest straps (fig.29).
CHANGING THE RECLINING POSITION OF THE SEAT (illustration 30)
• Press the lower lever on the front part of the seat (fig.30). It will click when correctly
fastened into each position.
REMOVING THE UPHOLSTERY (illustrations 31-34)
• Unfasten the harness clasp (fig.31).
• Undo the side clips of the upholstery (fig.32) and release the elastic strips from the lower
part of the frame (fig.33).
• Undo the two clips on the upper part of the backrest (fig.34).
• The upholstery can now be taken off
• To put the upholstery back on, follow the same steps in reverse order
Washing the upholstery
• Machine wash the upholstery at a maximum temperature of 30ºC and without using the
spin cycle. The painted or plastic parts should be cleaned using a non-abrasive polish
that does not contain solvents.
INSTRUCTIONS fOR USE
17