Hardware Setup; Quick Installation - D-Link DWR-932 Guia De Instalacion

HARDWARE SETUP

QUICK INSTALLATION

SI M
2
1. Remove the battery cover on the back of the device by
gently prying it up from the case using the corner notch, then
remove the battery.
2. Note the SSID (network name) and password on the label
on the battery cover. If you want to connect to the DWR-932
wirelessly, you will need to enter this SSID and password.
SI M
3. Slide the SIM card frame to the right and lift up. Insert the
SIM/UICC card into the SIM/UICC card slot as shown,
ensuring the gold contacts are facing down. Replace the
frame and slide it left to lock it in position.
Note: Install a MicroSD card at this time (optional)
4. Reinsert the battery and replace the battery cover.
5. Connect the Micro USB end of the USB cable to the Micro
USB port on the bottom of the DWR-932 and plug the USB
end into the USB port of a power adapter (not included) or a
PC to charge the battery.
6. Press and hold the power button for three seconds to turn
on the device. Once the power LED changes from green to
solid blue or amber, you may proceed with configuration.
DWR-932