Remote Controller Overview And Operations - Rheem RIWH07AVFJ Manual De Operación

Remote Controller Overview and Operations

• To prevent malfunction or damage of the remote controller:
- Place remote controller at where will not be exposed to
direct sunlight or excessive heat.
- Remove batteries if the product is not going to be used
for an extended period.
- Exhausted batteries must be removed immediately, and
be disposed according to the local laws and regulations
of your region.
1
5 Press CLOCK ADJUST button to start clock setting.
6 Set the time by pressing SELECT button.
Each time you press the button, the value increases or
decreases 1 minute. With pressing and holding the button, the
value increasesor decreases 10 minutes.
* By pressing the TEMP. () buttons, the time indicator can be
changed from a 24-hour to a 12-hour clock.
7 Press the CLOCK ADJUST button again to complete the clock
setting.
You can quickly start the operation with the following 3 steps:
1
Start/Stop button
2
MODE button
Switches operation mode in following order.
AUTO COOL
Notes in HEAT mode:
• At the beginning of the operation, the indoor unit operates at very
low fan speed for about 3–5 minutes for preparation, and then
switches to the selected fan speed.
• Automatic Defrosting operation overrides the heating operation
when necessary.
Battery (R03/LR03/AAA × 2) loading and remote controller preparation
3
2
DRY FAN HEAT
CAUTION
• If leaking battery fl uid comes in contact with your skin,
eyes, or mouth, immediately rinse with plenty of clean
water, and consult your physician.
• Obstacles such as a curtain or wall between the remote
controller and the indoor unit may affect the appropriate
signal transmission.
• Do not apply strong shocks to the remote controller.
• Do not pour water on the remote controller.
• Do not attempt to recharge dry batteries.
• Do not use dry batteries that has been recharged.
4
8
Press the °C / °F button to select the preferred temperature unit.
(Factory setting is °F.)
Notes:
• Use specifi ed type of batteries only.
• Do not mix different types or new and used batteries together.
• Batteries can be used about 1 year in ordinary use.
• If the remote control range noticeably shortens, replace the
batteries, and press RESET button as shown in page 5.
REG1U
3
TEMP. (temperature) buttons
Set the desired temperature.
In COOL or DRY mode, the temperature needs to be set lower than
the current room temperature. In HEAT mode, the temperature needs
to be set higher than the current room temperature.
Otherwise, corresponding operation mode may not start.
Temperature setting range
AUTO/COOL/DRY
HEAT
Notes: Temperature control is not available in FAN mode.
4
Remote controller display
In this section, all the possible indicators are displayed for description.
In actual operation, the display is linked with the button operation, and
only shows the necessary indicators for each setting.
AIR CONDITIONER Wall Mounted Type
5
7
64-88 °F (18-30 °C)
60-88 °F (16-30 °C)
OPERATING MANUAL
6
8
(continued)
En-3