Worx landroid WR140 El Manual Del Propietario página 28

Maintenance
Check which software version you have
The software version is always displayed on the left hand side of the display when you start up Landroid. You can also easily check
which software your Landroid has via the app.
WR143E
WELCOME
Ver: 3.40 Date: 20/02/2019
You can also check it by going into the General Settings menu.
• Press OK to select the gear icon
• Scroll down the menu with the down arrow key (B) to Diagnose option
• Press OK and you will see the Software version displayed again
Diagnose Info 1/10
Fw version: 3.40
Model: WR143E
S/N: 201830198511000001F5
Manual updates
• If your Landroid is not connected to your Wi-Fi network, you can still update it to the latest software version with a USB stick
• Regularly visit the Worx Landroid website to check if any new version is available. If you subscribed to Landroid email list, you will
be notified when a new version is available
• Download the latest software version at our website
• Unzip the file on your computer
• Take a blank USB stick formatted in FAT32
• Save the unzipped Landroid software to the USB stick
• Place Landroid on a secure and level surface
• Turn off Landroid
• Go to the rear of the Landroid to access the USB port. See page 7 of this manual to locate it
• Insert the USB stick in the port
• Place the Landroid on the lawn again, inside the working area delimited by the boundary wire
• Turn on Landroid
• Without lifting Landroid, remove the USB stick according to the screen tips
• The update will begin automatically and may take a while. Landroid will restart automatically after the update is completed
if Landroid is not inside the boundary wire, the message 'Outside working area Press START to reset' will be displayed.
NOTE:
Make sure Landroid is within the boundary when restarting Landroid.
28
EN