Worx landroid WR140 El Manual Del Propietario página 38

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Quick reference
Landroid runs outside the boundary
wire.
Landroid does not mow an area
within a
boundary wire zone.
Landroid reverses or rotates errati-
cally near the boundary wire.
Landroid slips out of its working
area going down a hill.
Landroid operative system crashes
when charging or on standby.
Landroid shuts off when docking in
the charging base.
Landroid stops in the working area. There is an obstacle in the working area. Remove the obstacle from Landroid's
Landroid flips over.
38
The boundary wire of another Landroid
or robotic mower is positioned too
closely.
In wet conditions, the boundary wire
electric signal may leak where the wire
has been joined or repaired incorrectly.
There is boundary wire electric signal
leakage due to broken insulation.
Low grip of Landroid drive wheels.
Software or display fault.
Landroid fails to charge due to over
temperature protection and is powered
off.
Poor connection.
The cutting height is set too low for the
length of the grass or the grass is too
dense.
The extended boundary wire should not
exceed 1145 ft or it may cause signal
problem.
The distance between the center of
the lawn and the boundary wire should
not exceed 82 ft or it may cause signal
attenuation.
There is an inclined obstacle on the
lawn.
Ensure at least 3 ft clearance is provided
in between your boundary wire and that
of your neighbor.
Check boundary wire joints. Insulate to
provide a fully waterproof connection.
Repair damaged boundary wire
with the wire connectors supplied.
Please check the wheels are clean and
free of mud in order to have the
maximum grip possible.
Restart Landroid.
Place the charging base in a shady area
or wait until the temperature has cooled
down.
Check the LED light on the charging
base.
Check the connection between the
contact pins located on the charging
base and the charging strip.
working area.
Raise the cutting height and then
gradually lower.
Reduce the length of the boundary wire.
Reduce the distance between the
center of the lawn and the boundary
wire perimeter within 82 ft.
Exclude the obstacle from Landroid's
working area.
EN

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Landroid wr143Landroid wr150Landroid wr153

Tabla de contenido