Introduction; Description; Spark Prevention; Assembly - Solar Charge it 4735 Manual De Propietario

Description

This battery charger is designed to handle the majority of your charging and starting needs.
• Fully automatic operation
• Multiple Charge Rates for various battery sizes.
• High-Amperage Engine Start to help start vehicles when the battery is too weak to do the job alone.
• Large Saw-Tooth Clamps assure good connection to top or side-mount battery terminals.
• Wheel and Handle Kit for easy mobility around your shop.

Spark Prevention

Make sure no sparks or flames occur near the battery, especially during charging. It takes very little to ignite the
explosive gasses produced by a lead-acid battery during the charging process. Read, understand and follow the
safety information provided in the Safety Summary section of this manual before attempting to work with or near a
lead-acid battery.
For more information about batteries and battery charging, contact Battery Council International at (312) 644-6610,
and request their Battery Service Manual, which is available for a nominal charge.
Assembly Instructions
1. Carefully remove the charger from the carton.
2. Unscrew the two screws in the handle bracket holding the handle in its downward position.
3. Remove the handle from the handle bracket.
4. Position handle in handle bracket, facing upward with bend facing forward, aligning holes with holes in
charger bracket.
5. Insert the two screws to secure the handle in position.

Charger Placement

Place the charger in a clean, dry, stable, well-ventilated spot as far from the battery as the DC output cables
permit.
NEVER place the charger directly above the battery being charged; gasses from the battery will corrode and
damage the charger.
NEVER allow battery acid to drip on the charger when reading specific gravity or filling the battery.
NEVER place a battery on top of the charger.
NEVER attempt to permanently mount this battery charger on a marine or recreational vehicle.
ALWAYS position the charger on the outside of a boat or recreational vehicle.

INTRODUCTION

ASSEMBLY

PREPARATION

7