Starting-Up And Using Instructions; Position Of The Machine And The Operator; Connection And Disconnection; Cutting By Tilting The Cutting Head - Carat EASYCOUPNEXT 350 Manual Del Usuario

9

STARTING-UP AND USING INSTRUCTIONS.

9.1 POSITION OF THE MACHINE AND THE OPERATOR; CONNECTION AND
DISCONNECTION
The machine must be installed on an even and stable Surface, free from obstacles and well lightened.
Before getting the machine started we need to check all the necessary elements (electrical connection, stability,
protective elements) as described in the previous sections.
The machine must be installed on an even surface, completely horizontal, and on stable and hard ground.
To start cutting, the operator must stand in front of the machine. In that position he will be able to easily move the
rolling cart with the piece to cut on top, and the electric supply switch will remain at hand.
Once the power supply cable is plugged in the motor will get started by pushing the Green start button. When the red
button is pushed the machine stop.

9.2 CUTTING BY TILTING THE CUTTING HEAD.

The machine can perform cuttings maintaining the Rolling cart fixed and tilting the cutting head down to cut. This is
how it should opérate for instance to cut interior windows in just one piece.
To perform this cut, the handle must be loosening up until the whole head is loose. The strain caused by the spring
will keep the cutting head up to the top. Then, the rolling cart with the material to cut will be pushed forward until the
material is under the blade: then use the handle to pull the head down to cut.
The strength used to push will depend on the hardness of the material and the cutting depth.
10
ENGLISH