Earth Wise LPS42410 Manual Del Operario página 4

INSTALLING/REPLACING THE GUIDE BAR AND CHAIN
DANGER: Never start the motor before installing the guide
bar, chain, chain cover and chain cover lock knob. Without
all these parts in place, the clutch can fly off or explode,
exposing the user to possible serious injury.
WARNING: To avoid serious personal injury, read and
understand all the safety instructions provided.
WARNING: Before performing any maintenance, make
sure the battery pack has been removed, failure to heed
this warning could result in serious personal injury.
CAUTION: Always wear gloves when handling the bar
and chain; these components are sharp and may contain
burrs.
WARNING: Never touch or adjust the chain while the
motor is running. The saw chain is very sharp; always wear
protective gloves when performing maintenance to the chain
to avoid possible serious lacerations.
NOTE: When replacing the guide bar and chain, use only
identical replacement parts.

Remove the battery pack from the pole saw

Loosen the lock knob by turning counter-clockwise.

Remove the chain cover.

Remove the bar and chain from the mounting surface.

Remove the old chain from the bar.

Lay out the new saw chain in a loop and straighten any
kinks. The cutters should face in the direction of the
chain rotation. If they face backwards, turn the loop over.

Place the chain drive links into the bar groove.
NOTE: Make certain of the direction of chain.

Position the chain so there is a loop at the back of the
bar.
4