Pre-Operating Instructions; Set Up - Weston PRO-1200 Manual De Instrucciones

PRE-OPERATING INSTRUCTIONS

• DO NOT operate the Dehydrator without the Feet / Casters installed.
• Locate the Dehydrator on a clean, level, dry, non-flammable, surface at
least 6" (15 cm) away from any wall. Avoid carpeted surfaces.
• Set the brakes on the two front-mounted Swivel Casters (160-L model) .

SET UP

1. Make sure the Power and Light
Switches are both set to "OFF."
2. Plug the Dehydrator into an electrical
outlet. DO NOT use extension cords.
3. Set the Power Switch to "ON."
4. Fill the Racks with food or other items to be dried.
5. Load the Racks in the Dehydrator. Push each Rack in until it stops.
IMPORTANT: There are three notched Racks. Place these Racks (with the
notch to the back) on the top three Rack Supports. The notches prevent the
Racks from touching the Temperature Sensor on the back inside wall near the
top. Any contact between these parts may cause false temperature readings
and/or cycle irregularities.
6. Close the Door, firmly press on the Door to ensure a good seal.
9