Aiphone JK-1MD Manual De Instalación Y Operación página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

6-3 Entrance monitoring
1
Press
MONITOR button in the standby mode.
2
The video monitor displays the image from the door station and the
incoming audio is heard. If you do not press
caller will not hear sounds from the inside station.
6-4 Room-to-room communication
1
Press
CALL button to talk with the other person.
• A call-in is sent to the sub station.
• The reply of the other person is not heard.
2
If the other person presses
communication is possible.
6-5 Wide/Zoom switching
1
Press
ZOOM/WIDE button when a picture is displayed.
Switching between wide ⇔ zoom occurs each time the button is
pressed.
TALK button, the
Or
TALK button, hands free
3
Press
OFF button to end communication.
NOTES:1. To talk to the entrance during entrance monitoring, momentarily
press
TALK button. This allows communication with the entrance.
2. The entrance monitoring turns off automatically after approx. 1
minute. To monitor the entrance again, repeat from the beginning.
3. During entrance monitoring, the monitoring time can be extended by
approx. 1 min. by pressing
4. During entrance monitoring, the wide picture display is used. Press
ZOOM/WIDE button to switch to the zoom picture.
5. At night, the Illuminator LED will not light up until
is pressed.
6. If another inside unit attempts to perform entrance monitoring while
one inside unit is already doing so, a warning beep sound will occur.
3
Press and release
OFF button to end communication.
NOTES: 1. Room-to-room communication ends automatically after approx. 10
minutes.
To perform room-to-room communication again, repeat from the
beginning.
2. If a call is received from the entrance during room-to-room
communication, the image from the entrance is displayed at the
monitor station and sub station where communication is taking
place. Press
OFF button to end the room-to-room communication,
and press
TALK button to switch to communication with the
door station.
[Wide picture]
NOTES: 1. When the caller is not shown in the center of the picture, the zoom
picture can be moved up, down, left, and right. (Refer to section
6-6)
When switching from the wide picture to the zoom picture, the
zoom picture starts at the pre-set (section 6-7) position.
The wide picture may be distorted in comparison with the zoom
picture due to the characteristics of the door station camera, but this
is not a malfunction.
- 8 -
MONITOR button.
TALK button
[Zoom picture]

Publicidad

Tabla de contenido
loading

Tabla de contenido