Troubleshooting - MGE Pulsar 700 Manual De Instalación Y De Usuario

E N G L I S H
5.1

Troubleshooting

If LED (21) or (22) is ON, a fault or an alarm has occurred. Use the escape button (24) to stop the audio alarm.
Display
The UPS does not start, the
alphanumeric display indicates:
1
COLD START NOK CHECK AC
WIRING
LED (22) is ON, the SWF LED
(11) at the rear of the UPS is ON.
The alphanumeric display indi-
cates: SITE WIR. FAULT CHECK
2
AC WIRING
LED (22) is ON, the alphanumeric
display indicates: NO BATTERY
3
CHECK CONNECTION
LED (22) is ON, the alphanumeric
display indicates: BATTERY
4
FAULT SERV REQUIRED
LED (21) is ON, the alphanumeric
display indicates: OVERLOAD
5
ALARM REDUCE LOAD
LED (22) is ON, the alphanumeric
display indicates: LOAD UNPRO-
6
TECTED OUTPUT OVERLOAD
LED (22) is ON, the alphanumeric
display indicates: REDUCE
LOAD RESTART UPS
7
LED (22) is ON, the alphanumeric
display indicates: OVERLOAD
8
FAULT REDUCE LOAD
LED (22) is ON, the alphanumeric
display indicates: LOAD SHORT-
9
CIRCU CHECK WIRING
LED (22) is ON, the alphanumeric
display indicates: INTERNAL
FAULT SERV REQUIRED
10
The alphanumeric display indi-
cates: REMOTE POWER OFF
11
RPO
86-86700-00 A01
Description
The AC input power is not con-
nected or is connected to the
UPS output.
Phase inversion on AC input
power. The UPS does not start.
The battery is incorrectly
connected.
A fault is detected on the battery.
The load level exceeds the pro-
grammed overload level or UPS
capacity.
The UPS is overloaded. Devices
connected to the UPS are fed
directly by the electrical network
via the By-pass.
After repetitive overloads, the
UPS is locked in the By-pass
position. Devices connected to
the UPS are fed directly by the
electrical network.
The UPS shut down automatically
because of overload at the UPS
output.
The UPS shut down automatically
because of a short-circuit at the
UPS output.
A UPS internal fault has occurred.
There are two possible situations:
◗ The load is still supplied, but
directly with AC power via the
bypass,
◗ The load is no longer supplied.
Switching of the Remote Power
Off (RPO) has led to the shut
down of the UPS.
Troubleshooting
Troubleshooting
Corrective Action
Check the UPS is correctly connected
to the AC input power.
◗ In an earthed-neutreal system, to
correct the wiring, call an electrician to
modify the connections.
◗ For all other types of system, disable
the detection function.
Check battery connections (see
Section 5.2, Battery-Module
Replacement).
Replace the battery (see Section 5.2,
Battery-Module Replacement). Call the
after-sales support
Check the power drawn by the con-
nected devices and disconnect any
non-priority devices. Check the pro-
grammed overload level.
Check the power drawn by the con-
nected devices and disconnect any
non-priority devices.
Check the power drawn by the con-
nected devices and disconnect any
non-priority devices. Shut down and
restart the UPS to return to normal
operation.
Check the power drawn by the con-
nected devices and disconnect any
non-priority devices.
Check the installation at the UPS out-
put (wiring, fault equipment).
Call the after-sales support depart-
ment.
Replace the contact in the normal
position, and press the ON/OFF button
to restart.
5 — 1