HoMedics BPA-260-CBL Manual página 12

2. With the cuff wrapped around your arm, press the START/
STOP button. Do not inflate the cuff unless it is wrapped
around your arm. All digits will light up to check the display
functions. The checking procedure will be completed after
about 3 seconds.
Note: If using the Voice Assist
you will be prompted to press the START/STOP
button again before measurement begins.
3. After all symbols disappear, the display will show
"00". The monitor is "Ready to Measure" and will
automatically inflate the cuff to start measurement.
4. The cuff will begin deflating as measurement continues.
Note: This monitor will re-inflate automatically if the system
detects that your body requires more pressure for measurement.
®
"Instructions On" mode,
21
5. When the measurement is completed, the cuff will
deflate entirely. Systolic pressure, diastolic pressure
and pulse will be shown simultaneously on the LCD
screen. The measurement is then automatically
stored into memory.
Note:
1. This monitor automatically turns off approximately 1
minute after last operation. You may also press the
START/STOP button to turn the unit off.
2. To interrupt the measurement, you may press the
START/STOP (recommended), M, LANGUAGE,
TALKING MODE, USER-SELECT or DATE/TIME SET
( ) buttons. The cuff will deflate immediately after a
button is pressed.
22