I Nst All Ing A Nd Co Nnecti Ng - NAIM SUPERUNITI Guia De Inicio Rapido

SuperUniti Quick Start Guide

1 I nst all ing a nd Co nnecti ng

power switch
mains input
and fuse
• Stand SuperUniti on an appropriate, stable surface. Make sure SuperUniti is well
ventilated.
• Check that the mains supply specified on the SuperUniti rear panel is appropriate for
your territory. Connect SuperUniti to the mains using the supplied cable but do not
switch it on until all other connections have been made.
• Identify the
Signal Ground Switch
connected in a hi-fi system incorporating another earthed source component (all
Naim CD players, for example), or mains "hum" is audible through the loudspeakers
when SuperUniti is switched on.
• Connect the left and right speakers to the
when connecting speakers that the positive and negative connection orientation at
both ends of the cable is the same for both channels.
• If an external power amplifier and/or subwoofer is to be used, connect their signal
cables respectively to the
panel.
• To play audio from a
UPnP™
network socket must be connected to a router using an Ethernet cable, or its
Antenna must be fitted. Internet radio also requires a high-speed internet connection.
• If the SuperUniti
daB/Fm
to the DAB/FM aerial socket. The DAB/FM radio cannot operate without an aerial.
Contact your local Naim retailer or distributor for advice on selecting and installing an
aerial.
• If SuperUniti is to play audio files stored on an
connect it, using an appropriate cable if necessary, to the front panel USB socket.
• If any external audio sources are to be used with SuperUniti, connect them, using the
appropriate cables, to the rear panel
Full Superuniti installation and operational information can be found in the reference manual
left right
speaker speaker
and select the "chassis" option unless SuperUniti is
speaker outputs
preamp out or sub out connectors on the SuperUniti rear
server or from internet radio stations, the SuperUniti
radio is to be used a suitable aerial should be connected
iPod ,
analogue or
available on line at www.naimaudio.com
network socket
wireless network
(Wi-Fi) antenna socket
signal ground switch
preamp output
on the rear panel. Ensure
iPhone or on USB memory hardware,
digital inputs.
digital output
subwoofer
analogue
output inputs
Wi-Fi
Note:
MP3 players may be
connected to the SuperUniti
front panel analogue input
using a 3.5mm stereo jack
cable from their headphone
sockets.
English
digital
inputs
DAB/FM aerial
socket