Grill Module; Surface Burner - GE JGP979 Manual Del Propietario E Instrucciones De Instalación

Surface burner and grill modules.
Throughout this manual, features and appearance may vary from your model.
10
Sealed Burner Module
To Install the Sealed Burner Module:
1. Make sure that all control knobs are
set to OFF.
2. Clean the cooktop basin to remove
any grease accumulation. See the Care
and Cleaning the Cooktop section.
3. With the back of the burner module
tilted up and the mixer tube openings
and ignitor rods facing the orifices
and terminal receptacle, insert the
module in the cooktop basin.
To Remove the Sealed Burner Module:
1. Make sure that all control knobs are
set to OFF and that the cooktop is cool.
2. Lift up the edge of the burner module
until the bottom of the module clears
the edge of the basin.
IMPORTANT: Do not lift the module too
high while it is still connected—you could
damage the ignitor rods and mixer tubes.

Grill Module

The grill consists of two black grill grates and the grill burner. Only install the grill on the left
side of your cooktop.
To Install the Grill Module:
1. Make sure that all control knobs are
set to OFF.
2. Position the grill burner with the
mixer tubes and ignitor rod facing the
orifices and terminal receptacle.
3. Slide the grill burner forward until the
tubes and ignitors are engaged; then
lower the burner until it rests on the
mounting pins.
To Remove the Grill Module:
1. Make sure that all control knobs are
set to OFF and all grill components are
cool.
2. Remove the grill grates.
3. Lift the grill burner up slightly and
pull it away from the terminal
receptacle and orifices. Lift it out of
the basin when it is completely
unplugged.
4. Slide the burner module forward until
the tubes and ignitors start to engage.
5. Lower the back of the module into
place and carefully slide it forward
until the mixer tubes and ignitor rods
are fully engaged.
3. Hold the module by the sides and pull
it away from the terminal receptacle
and orifices. Lift it out of the basin
when it is completely unplugged.
4. Do not store or stack modules where
they could fall or be damaged.
NOTE: The optional sealed burner
module JXGB79 can replace the grill
burner assembly.
4. Carefully place the grill grates on the
cooktop.
NOTE: Before using the grill for the first time,
heat the grill burner to remove the protective
shipping coating. Heat the grill burner on HI
for 10 minutes and use the vent system to
remove any additional smoke during cooling.
4. Do not store or stack modules where
they could fall or be damaged.
NOTE: The optional sealed burner
module JXGB79 can replace the grill
burner assembly.