Adjusting The Handle - Sears Craftsman 358.791031 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Shield
Slot
PIVOT
Bracket
Line Limiter
Blade
Wing
Nut
ADJUSTING
THE HANDLE
,_WARNING:
When adjusting tile
handle, be sure it remains above the
safety label and below the mark or ar-
row on the shaft.
1. Loosen wing nut on handle.
2.
Rotate the handle on the shaft to an
upright position; retighten wing nut.
KNOW YOUR TRIMMER
READ THiS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourself with the location of
the various controls and adjustments.
Save this manual for future reference.
Muffler
Assist Handle
Trimmer
Head
Shaft
Shield
/
Line Limiter
Blade
Coupler
Throttle
Trigger
Spark
Plug
Primer
Bulb
Start
Lever
ON/STOP
Switch
Starter
Handle
ON/STOP
SWITCH
The ON/STOP switch is located on the
trigger handle and is used to stop the
engine. To stop the engine, push and
release the engine ON/STOP switch.
PRIMER BULB
The PRIMER BULB removes
air from
the carburetor
and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
by pressing it and allowing it to return
to its original form.
START LEVER
The START LEVER helps to supply fuel
to the engine to aid in starting. Acti-
vate the starting system by moving the
start lever to the START position. DO
NOT squeeze
the throttle trigger until
the engine has started and runs. After
the engine starts, allow the engine to
warm-up
10-15 seconds, then fully
squeeze
the throttle trigger to deacti-
vate the starting system (start lever
returns to RUN position).
COUPLER
The COUPLER enables
optional at-
tachments
to be installed on the unit.
11

Publicidad

Tabla de contenido
loading

Tabla de contenido