Lessar LS-HE09KLA2B Manual Usuario página 70

• Setting Angle of Air Flow
Setting vertical angle of air flow
While the unit is on, use the SWING
/DIRECT button to set the direction (vertical
angle) of airflow.
1. Press the SWING /DIRECT button once
to activate the louver. Each time you
press the button, it will adjust the louver
by 6°. Press the button until the direction
you prefer is reached.
2. To make the louver swing up and down
continuously, press and hold the
SWING/ DIRECT button for 3 seconds.
Press it again to stop the automatic
function.
Setting horizontal angle of air flow
The horizontal angle of the airflow must be
set manually. Grip the deflector rod (See
Fig.2.3) and manually adjust it to your
preferred direction. For some units, the
horizontal angle of the airflow can be set by
remote control. Please refer to the Remote
Control Manual.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set
louver at too vertical an angle for long periods
of time. This can cause water to condense on
the louver blade, which will drop on your floor
or furnishings. (See Fig. 2.2)
When using COOL or HEAT mode, setting
the louver at too vertical an angle can
reduce the performance of the unit due to
restricted air flow.
Do not move louver by hand. This will cause
the louver to become out of sync. If this occurs,
turn off the unit and unplug it for a few
seconds, then restart the unit. This will reset
the louver.
Page 10


Caution: Do not keep louver at too
vertical an angle for long periods of
time. This can cause water condensation
to drip on your furnishings.
Fig. 2.2
CAUTION
Do not put your fingers in or near the blower
and suction side of the unit. The high-speed
fan inside the unit may cause injury.
Deflector rod
Fig. 2.3