Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions
**READ MANUAL BEFORE STARTING**
Starting Instructions
It is recommended that you read the entire manual
before starting the Mosquito Magnet
®
trap.
1. Insert attractant in compartment per instructions in
attractant packaging.
2. Connect regulator to propane tank (see page 8).
3. Plug power connector into the trap.
4. Plug AC adapter into electrical socket. (To avoid the
risk of electrical shock, connect only to properly
grounded outlets.) Adapter unit is not intended to be
mounted.
5. Slowly turn propane tank valve on.
6. Turn rocker switch to "on" position.
7. The red light on the switch will flash for up to 20
minutes (warm up phase).
8. Once the light stops flashing and is solid, the Mosquito
Magnet
®
is fully operational.
NOTE:
Should you experience an interruption of power,
be sure to restart trap.
Shut Down Instructions
To shut down the Mosquito Magnet
®
simply close the valve
on the propane tank and switch to the "off" position.
When Not In Use
If the unit is not in use, the gas must be turned off at the
supply cylinder. Storage of this unit indoors is permissible only
if the cylinder is disconnected and removed. Cylinders must
be stored outdoors, out of reach of children and must not be
stored in a building, garage or any other enclosed area.
End of Season Storage
Push ON/OFF switch to OFF position to shut down the trap.
The LED light will go out and the fan will continue running
until trap is cool. Close the propane tank valve
and disconnect regulator.
Any open Mosquito Magnet
attractant should be removed
®
and discarded. See attractant label for disposal instructions.
The bug bag should also be discarded prior to storing the trap.
STORAGE:
The trap should be stored indoors in a garage
or shed in the off-season. Cover trumpet to prohibit insects
from nesting. Cover unit with trap cover available at
www.mosquitomagnet.com or with a tarp and secure tightly
at the bottom to keep out dust, spider webs and other debris.
NOTE:
It is recommended that you use the Quick Clear
adapter before seasonal storage to avoid build-up
of contaminants during off-season (see page 13).
11
For Best Results (unit must run for 24 hours/day)
• Your trap will begin capturing immediately with
significant reduction in the mosquito population in
7-10 days. Allow 4 weeks to significantly reduce the
mosquito population in your yard.
• Allow trap to cool for 5 minutes before re-start.
• Never spray insecticide in or around trap.
• Trap can be left running in the rain.
• If using lime or fertilizer compounds, be sure to shut
down the trap first to prevent dust or fine mist from
being drawn into trap and clogging bug bag.
Warning: Improper installation, adjustment, alteration,
service or maintenance can cause injury or property
damage. Read the installation, operating and
maintenance instructions thoroughly before installing
or servicing this equipment.
Caution: The gas pressure regulator provided with this
appliance must be used. This regulator is set for an
outlet pressure 11.0 in. water column.
The gas supply must be turned off at the LP-Gas
supply cylinder when this appliance is not in use.
Leader in 360º Customer Support
• Customer Care Hotline: 1-800-953-5737
• Online Product Registration Available
• Visit www.mosquitomagnet.com for
Troubleshooting Tips/Trap Placement
• Certified Service Locations – Information Available
at www.mosquitomagnet.com
Maintenance
Maintenance
• 21 Day Maintenance Cycle
- Refill propane. (Propane lasts approximately 21 days with
24-hour/7-days operation.)
- Replace short-range attractant cartridge.
See Mosquito Magnet
attractant label for instructions.
®
- Empty or replace bug bag.
- Utilize the Quick Clear adapter at every tank change.
• Periodically wipe down the outside of the trap
with a clean, water damp cloth.
Note: Bug bags should be replaced when half full. You can find all your accessory needs at
Maintenance Schedule
www.mosquitomagnet.com or at your Certified Mosquito Magnet
Example
Purchase Date
4/1
Register Warranty
4/1
Start Up Date
4/1
SERVICE:
Seasonal Tune-Up
MAINTENANCE:
Propane & Attractant Change
4/21
Quick Change Cartridge
4/21
Propane & Attractant Change
5/11
Quick Change Cartridge
5/11
Propane & Attractant Change
5/31
Quick Change Cartridge
5/31
Propane & Attractant Change
6/20
Quick Change Cartridge
6/20
Propane & Attractant Change
7/10
Quick Change Cartridge
7/10
SERVICE - WINTERIZATION
Discard Bug Bag & Attractant
Cover Trap Trumpet to avoid
nesting insects
Keep in garage or shed
Propane Tank Changing Time
When attaching the regulator knob to a tank after a tank
change, be sure to fully tighten the regulator knob onto the
tank. No need to use tools, but do turn the knob as far as
possible by hand. When this is done, loosen the knob 1/4 turn,
then re-tighten to maximize seal.
The purpose for this is to fully engage the regulator onto the
tank. If the regulator is not fully engaged, the flow of gas
may be restricted to the point where the trap will show a gas
empty code. If this occurs, press the off button, close the tank
valve, and remove the regulator from the tank. Re-attach the
regulator and try again.
Hardware or Home Improvement Store.
®
Season 1
Season 2
Season 3
Season 4
3/15
12
Publicidad
