LG LT1030HR Manual Del Propietário página 18

Operating Instructions
The controls will look like one of the foflowing.
-FAN SPEED
• Everytime you push this button,it advances the setting as follows: {High[F2 ] _ Low[F1 ] _ High[F2 ]}
(-TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the Temperature
setting will raise 2°F after 30 min., and once again after another
30 rain.
• Push Timer button to advance setting from 1Hour * 2Hours _ ...
• 12Hours maximum.
- START TIME
• If unit is off, use Timer to set number of hours before unit starts.
• Push Timer button to advance setting from 1Hour * 2Hours _ ...
12Hours maximum.
MODE
REMOTECONTROLSIGNAL
RECEIVER
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range of
60°F to 86°F by increments of I°F.
• The setting appears in the display.
POWER
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button
again.
• This button takes priority over any other button.
- Push this button to shift mode of operation from COOL _ ENERGY SAVER * FAN * HEAT
- COOL:
• Fan runs continually for normal cooling operation.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will
check the room air temperature to determine if cooling is needed.
- FAN:
• Fan-only operation.
- HEAT:
• Fan runs continually for normal heating operation.
_d after an electrical power failure, the unit will begin to run at its last setting. J
18 Room Air Conditioner