Install Support Brackets - TCL 15K Manual Del Usuario

Fasten the cabinet to the window sill using two 5/8" round head screws. Pre-drill holes if
3.
needed. Add the bottom rail seal over the screws.
Step 5:

Install Support Brackets

Hold each support bracket flush against the outside of the window sill. Tighten each bracket
1.
to the bottom of the cabinet as shown below. Mark the brackets at the top level of the
window sill and then remove.
Assemble the sill angle brackets to the support brackets at the marked position as shown
2.
below. Hand tighten, but not all the way for any changes that may be needed to be made
later during the installation.
Mark
Mark
Left
Left
Locknut
Locknut
Sill Angle
Sill Angle
Bracket
Bracket
5/8" Long Flat Head Bolt
5/8" Long Flat Head Bolt
Bottom
Rail Seal
5/8" Round Head Screw
1/2" Long Flat Head
1/2" Long Flat Head
Bolt and Locknut
Bolt and Locknut
Right
Right
(2) required
(2) required
for each support bracket
for each support bracket
8