Unpacking Instructions - Fanimation DISTINCTION D1 Serie Manual Del Usuario

This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan
Tools Needed for Assembly
blade screwdriver
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 11). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in finding your place should you be interrupted.
WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration.
Hanger Bracket
Assembly
Sloped
Downrod/
Hanger Ball
Hanger Ball
Assembly
Canopy Assembly
Four wire connectors
(supplied)

Unpacking Instructions

Canopy Trim Ring
Assembly
Motor Coupling
Cover Assembly
Motor Assembly
Materials
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
• Motor Assembly
• Hanger Bracket Assembly
• Downrod/Hanger Ball
Assembly
• Sloped Hanger Ball
• Canopy Assembly
• Canopy Trim Ring Assembly
• Motor Coupling Cover
Assembly
• Blade Holder Cover Set
• Blade Holder Set
• Adapter-Switch Housing
Assembly
• Inner-Switch Housing
Assembly
• Switch Housing Cover
• Cover Switch Housing
• Hand-held Remote
Switch Housing Cover
Adapter-Switch Housing
Assembly
Blade Holder Cover Set
Inner-Switch Housing
Assembly
4
Wire Size A.W.G.
14
12
• Hardware Bag:
– 1/4˝-20 Phillips head screws
with lockwashers
(blade holder to fan motor hub)
– #8-32 Serrated head screw-Short
– #8-32 Serrated head screw-Long
(blade holder to blade holder)
– Wire connectors
– Phillips Screwdrive, 4˝
– Balance Kit
Cover Switch Housing
Hardware Bag
Blade Holder Set
Hand-held
Remote