TAKATA MINI I-SIZE Manual De Instrucciones página 72

NOTE!
[MINI_I-SIZE_050] Check the TAKATA MINI I-SIZE
is correctly secured to the TAKATA I-SIZE BASE, by
gently shaking the seat in each direction. If the seat is
not properly secured to the base, repeat Step 2 – Lock
the seat into the TAKATA I-SIZE BASE until it is in
the correct position.
Removing the TAKATA MINI I-SIZE from the
TAKATA I-SIZE BASE
Step 1 – Release the rear connection hooks
[MINI_I-SIZE_047 + MINI_I-SIZE_034] The rear
hooks unlock together, so you only need to push down
one of the release elements on the TAKATA I-SIZE
BASE rear connection arms. At the same time, tilt the
TAKATA MINI I-SIZE forward (in the direction of
travel), so that the connection bolts of the seat come out
of the rear connection hooks of the TAKATA I-SIZE
BASE.
68
Step 2 – Free the seat from the front connection hooks
and remove
[MINI_I-SIZE_034] Free the connection rod of the
TAKATA MINI I-SIZE from the front hooks of the
TAKATA I-SIZE BASE by sliding the TAKATA MINI
I-SIZE backward, against the direction of travel. You
should now be able to lift the TAKATA MINI I-SIZE
from the TAKATA I-SIZE BASE, and remove it from
your vehicle.
Removing the TAKATA I-SIZE BASE
Step 1 – Unlock the ISOFIX connectors
[MINI_I-SIZE_033] Separate the connectors on the
TAKATA I-SIZE BASE from the ISOFIX points in the
vehicle, by moving the locking sliders of the release
sliders down and, at the same time, pulling the release
slider on each connector forward (in the direction of
travel). The components have been separated if a red
marking can be seen on the top of each ISOFIX connector.