Software Update - Zircon Leak Alert WiFi Manual Del Usuario

5. PLACEMENT
The Leak Alert WiFi water detector should be
™
placed flat against the floor surface, with the
metal contacts touching the surface.
The Detector cannot detect water leakage if
metal sensors are not touching the floor surface
where water would appear if a leak occurs.
Placement of The Detector must
be within range of the router.
The Detector floats when the battery is properly
installed. An alarm will sound for the life of the
battery, or until the unit is deactivated. An email
notification will be sent every 10 minutes for the
first hour the leak is detected, and once every
hour afterwards until the battery dies.
The Detector may also be placed on its side
with metal contacts touching the surface.
However, it may not float if placed this way.

6. SOFTWARE UPDATE

A badge (small red dot) over the Help icon signifies an available
software update. Press the icon and press the "Yes" button to update
before proceeding. Once complete, repeat the steps in Sections 2 and 3.
We strongly recommend registering
your Detector so that you can
receive the latest product
information such as updated
instructions, new videos and
availability of software updates.
To register, go to http://www.zircon.
com/support/product-registration.
Help Icon
192.168.4.1
HELP
Zircon Corporation
1580 Dell Ave.
Campbell, CA 95008
+1 408 963-4550
http://www.zircon.com
Support
+1 800 245 9265
@
techsupport@zircon.com
SOFTWAREVERSION: v2.0.164
New Software updates available.
Do you wish to update now?
YES NO
8