VOX Amplification VT100X Manual De Usuario página 5

the parameters in the valve section and noise reduction are switched to
the standard settings for each amp model. In preset programs mode, this
knob is used to recall a preset program.
At USER A, USER B and USER C, an amp model customized by
Tip
using Editor/Librarian software can be stored.
GAIN knob
This adjusts the pre-amp gain of the selected amp
model. This setting will change the amount of the pre-
amp's distortion.
TREBLE, MIDDLE and BASS knobs
These adjust the high, mid, and low-
frequency ranges. The changes that
are produced differ depending on the
selected amp model.
The Editor/Librarian software, can
Tip
be used to make more detailed
adjustments to the tone.
VOLUME knob
This adjusts the level of volume that is output from the
pre-amp to the power amp. This setting will alter the
amount of power amp distortion.
The amount of power amp distortion is also
affected by the GAIN knob. On some settings, there
will be almost no distortion.
c . POWER LEVEL knob
This adjusts the output level of the power amp while
maintaining the level of power amp distortion.
The POWER LEVEL setting is not saved with the
programs.
This also adjusts the output level from the
Tip
headphones jack (p. 6) when headphones are plugged into the jack.
However, the input from the AUX IN jack (p. 6) is not affected.
d . USER PROGRAMS section
FOOT SW jack
You can connect an optional VOX VFS5 foot switch here.
For more information on using the foot switch, refer to
"Using the foot switch (VOX VFS5)" on page 9.
You must connect or disconnect the VFS5 when the
power is off. Malfunctions or damage may occur if
you connect or disconnect the foot switch while the power is on.
BANK button and channel buttons (CH1, CH2, CH3 and CH4)
Use the BANK button to select a channel
bank, and then press a channel button to
select a channel (program) within the bank
("About the three modes" on page 7).
These buttons are also used to save new programs ("Saving a program" on page 8).
When the tuner function is engaged, these buttons will display the
tuning status ("Using the tuner" on page 8).
USB port
Use this port and a commercially available USB cable to
connect your amplifier to a computer, etc.
e . EFFECTS section
Effect selection buttons (PEDAL1, PEDAL2 and REVERB)
Effect type LEDs
Use these buttons to adjust the effects and choose
an effect type. The selected button will begin
blinking to indicate that it has been chosen to be
edited. Use the TAP button and VALUE 1 and
VALUE 2 knobs to adjust the selected effect.
Press any effect selection button while it is
blinking to select an effect type.
An effect type LED will illuminate to indicate
your selection. Hold down an effect selection
button to turn it off and turn off the effects.
When the tuner function is engaged the effect selection buttons will display the
tuning status ("Using the tuner" on page 8).
- 5 -
VT100X Owner's manual
Effect selection bu ons
Effect type LEDs