Commissioning And Operation - Klarstein Lagoona Manual De Instrucciones

EN
64

COMMISSIONING AND OPERATION

Starting the washing process
1. Pull out the lower and upper baskets, fill the baskets with dishes and push them
back into the appliance. It is recommended to fill the lower basket before the upper
basket.
2. Add the dishwashing detergent.
3. Plug the mains plug into the socket. Make sure that the main tap of the water is fully
open.
4. Close the door and press the button to turn on the appliance.
5. When you have selected a program, the corresponding indicator light will
illuminate. Press the Start/Pause key to start the dishwasher.
Changing the programme
A program can only be changed if the device has been running for a short time.
Otherwise the dishwasher detergent may already have been released and the
dishwasher may already be full of water. If this is the case, the appliance must be reset
and the dispenser must be refilled with dishwashing detergent. Proceed as follows to
reset the dishwasher:
1. Press the Start/Pause key to pause the washing process.
2. Press the PROGRAM button for longer than 3 seconds to cancel the current
programme.
3. Select the desired program with the PROGRAM button.
4. Press the Start/Pause button to start and after 10 seconds the dishwasher will start
the new programme.